Assembly instructions
for the DaRi system D3 for box gutters
The DaRi system parts D3 can be adapted to different box gutter sizes.
They can be adjusted in both height and width.
Two system parts are always plugged together.
Step 1
Correct height
There are cutting grooves on the back of the DaRi system parts D3.
The parts can be shortened to the correct height along these grooves.
The numbers on the cutting grooves indicate the gutter size.
The parts are shortened over their entire length using a cutter knife.
The correct height must be measured for non-standard guttering.
Step 2
Correct width
The two DaRi system parts D3 can overlap to different extents and be snapped into different positions.
This allows the width to be changed flexibly.
When joining 2 DaRi system parts together, make sure that the holes in the overlapping area are open on top of each other (see below).
Step 3
Overlap area
In the overlapping area of the two DaRi system parts, the holes should be as open as possible:
Step 4
Sheet metal tongues
Before installation, the sheet metal tongues must be bent to the gutter:
